8,460
个编辑
更改
→USB以太网卡测试
# 目前'''测试过'''能用的USB以太网卡如下所示，其中RTL8153 USB千兆网卡插入开发板的USB 2.0 Host接口中测试可以正常使用，但是速率是达不到千兆的，这点请注意
::{| class="wikitable" style="width:800px;text-align: center;"
|-
| 序号
<ol start="2" style="list-style-type: decimal;">
<li><p>首先将USB网卡插入开发板的USB接口中，然后在USB网卡中插入网线，确保网线能正常上网，如果通过'''dmesg'''命令可以看到下面的log信息，说明USB网卡识别正常</p>
{| class="wikitable" style="width:800px;"
|-
|
<p>orangepi@orangepi:~$ '''dmesg | tail'''</p>
<p>[ 121.985016] usb 3-1: USB disconnect, device number 2</p>
<p>[ 127.763031] IPv6: ADDRCONF(NETDEV_UP): enx00e04c362017: link is not ready</p>
<p>[ 129.892465] r8152 3-1:1.0 enx00e04c362017: carrier on</p>
<p>[ 129.892583] IPv6: ADDRCONF(NETDEV_CHANGE): enx00e04c362017: link becomes ready</p>|}</li>
<li><p>然后通过ifconfig命令可以看到USB网卡的设备节点，以及自动分配的IP地址</p>
{| class="wikitable" style="width:800px;"
|-
|
<p>orangepi@orangepi:~$ '''sudo ifconfig'''</p>
<p>'''enx00e04c362017''': flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500</p>
::<p>inet '''192.168.1.177''' netmask 255.255.255.0 broadcast 192.168.1.255</p>::<p>inet6 fe80::681f:d293:4bc5:e9fd prefixlen 64 scopeid 0x20<link></p>::<p>ether 00:e0:4c:36:20:17 txqueuelen 1000 (Ethernet)</p>::<p>RX packets 1849 bytes 134590 (134.5 KB)</p>::<p>RX errors 0 dropped 125 overruns 0 frame 0</p>::<p>TX packets 33 bytes 2834 (2.8 KB)</p>::<p>TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0</p>|}</li>
<li><p>测试网络连通性的命令如下</p>
{| class="wikitable" style="width:800px;"
|-
|
<p>orangepi@orangepi:~$ '''ping www.baidu.com -I enx00e04c362017'''</p>
<p>PING www.a.shifen.com (14.215.177.38) from 192.168.1.12 eth0: 56(84) bytes of data.</p>
<p>--- www.a.shifen.com ping statistics ---</p>
<p>4 packets transmitted, 4 received, 0% packet loss, time 3002ms</p>
<p>rtt min/avg/max/mdev = 6.260/6.770/7.275/0.373 ms</p>|}</li></ol>
<span id="usb摄像头测试"></span>
=== USB摄像头测试 ===
